Users Guide

set extcommunity bandwidth
Enables you to set extended community bandwidth.
Syntax
set extcommunity bandwidth
To disable extended community bandwidth, enter the no set extcommunity
bandwidth command.
Parameters
bandwidth Enter the keyword bandwidth to enable extended community
bandwidth. The range is from 0 to 102400.
Defaults N/A
Command Modes ROUTER MAP
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S-Series.
Usage Information
A new policy command is introduced in order to attach the Link Bandwidth extended
community only to the prefixes that are received from a neighbor that satisfy the
desired conditions. This command is relevant for both inbound as well as outbound
policy handling (for received prefixes). Also, there is no change to the set of supported
conditions or filters.
During configuration, the bandwidth is specified in Mbps, not in bytes/second. While
creating the actual LB extended community, the system will attach the AS number and
encode the bandwidth in floating point format.
show capture bgp-pdu neighbor
Display BGP packet capture information for an IPv4 address on the system.
Syntax
show capture bgp-pdu neighbor ipv4-address
Border Gateway Protocol 464