Users Guide

If you configure the set weight command in a route map applied to this neighbor,
the weight set in that command overrides the weight set in the neighbor weight
command.
Related
Commands
• set weight — assign a weight to all paths meeting the route map criteria.
network
Specify the networks for the BGP process and enter them in the BGP routing table.
Syntax
network ip-address mask [route-map map-name]
To remove a network, use the no network ip-address mask [route-map map-
name] command.
Parameters
ip-address Enter an IP address in dotted decimal format of the network.
mask
Enter the mask of the IP address in the slash prefix length format
(for example, /24).
The mask appears in command outputs in dotted decimal
format (A.B.C.D).
route-map map-
name
(OPTIONAL) Enter the keyword route-map then the name of an
established route map.
Only the following ROUTE-MAP mode commands are
supported:
• match ip address
• set community
• set local-preference
• set metric
• set next-hop
• set origin
• set weight
If the route map is not configured, the default is deny (to drop
all routes).
Defaults Not configured.
Command Modes ROUTER BGP
Border Gateway Protocol 456