Users Guide

Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.8.0 Support from 2 to 64 paths on the S4810. Command syntax
changed to max-path (was maximum-paths).
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage Information If you enable this command, use the clear ip bgp * command to recompute the
best path.
neighbor activate
This command allows the specified neighbor/peer group to be enabled for the current AFI/SAFI (Address
Family Identifier/Subsequent Address Family Identifier).
Syntax
neighbor [ip-address | peer-group-name] activate
To disable, use the no neighbor [ip-address | peer-group-name] activate
command.
Parameters
ip-address (OPTIONAL) Enter the IP address of the neighbor in dotted
decimal format.
peer-group-name (OPTIONAL) Enter the name of the peer group.
activate Enter the keyword activate to enable the neighbor/peer
group in the new AFI/SAFI.
Defaults Disabled
Command Modes CONFIGURATION-ROUTER-BGP-ADDRESS FAMILY
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Border Gateway Protocol 424