Users Guide

Version Description
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
7.2.1.0 Introduced.
Usage Information
This command turns on BGP soft-reconfiguration inbound debugging. If no neighbor is
specified, debug turns on for all neighbors.
debug ip bgp updates
Allows you to view information about BGP updates.
Syntax
debug ip bgp [vrf vrf-name] [A.B.C.D | X:X:X:X::X | peer-group
peer-group-name] updates [in | out | prefix-list prefix-list-name]
To disable debugging, use the no debug ip bgp [vrf vrf-name] [A.B.C.D |
X:X:X:X::X | peer-group peer-group-name] updates [in | out |
prefix-list prefix-list-name] command.
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of the
VRF to view BGP updates information corresponding to that
VRF.
A.B.C.D (OPTIONAL) Enter an IPv4 address of the neighbor.
X:X:X:X::X (OPTIONAL) Enter an IPv6 address.
peer-group peer-
group-name
(OPTIONAL) Enter the keyword peer-group followed by the
name of the peer group.
in (OPTIONAL) Enter the keyword in to view only BGP updates
received from neighbors.
out (OPTIONAL) Enter the keyword out to view only BGP updates
sent to neighbors.
prefix-list prefix-
list-name
(OPTIONAL) Enter the keyword prefix-list then the name of
an established prefix list. If the prefix list is not configured, the
default is permit (to allow all routes).
Border Gateway Protocol 419