Users Guide

Version Description
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.8.1.0 Increased the name string to accept up to 140 characters. Prior
to 7.8.1.0, names are up to 16 characters long.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
Example
Dell# show ip prefix-list summary
Ip Prefix-list with the last deletion/insertion: PL_OSPF_to_RIP
ip prefix-list PL_OSPF_to_RIP:
count: 3, range entries: 1, sequences: 5 - 25
Dell#
Route Map Commands
When you create an access-list without any rule and then applied to an interface, the ACL behavior reflects
implicit permit.
To configure route maps and their redistribution criteria, use the following commands.
continue
To a route-map entry with a higher sequence number, configure a route-map.
Syntax
continue [sequence-number]
Parameters
sequence-
number
(OPTIONAL) Enter the route map sequence number. The range
is from 1 to 65535.
Defaults Not configured.
Command Modes ROUTE-MAP
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
Access Control Lists (ACL) 270