Users Guide

Version Description
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.5(0.0) Introduced on the Z9000, S6000, S4820T, S4810, and MXL.
Usage Information You can use the both command to migrate from VRRPv2 to VRRPv3. When you set the
VRRP protocol version to both, the switch sends only VRRPv3 advertisements but can
receive either VRRPv2 or VRRPv3 packets. To migrate an IPv4 VRRP group from VRRPv2
to VRRPv3:
1 Set the switches with the lowest priority to both.
2 Set the switch with the highest priority to version 3.
3 Set all the switches from both to version 3.
NOTE: Do not run VRRP version 2 and version 3 in the same group for an
extended period of time.
Example
Dell(conf-if-te-1/1/1-vrid-100)# version ?
2 VRRPv2
3 VRRPv3
both Interoperable, send VRRPv3 receive
both
Dell(conf-if-te-1/1/1-vrid-100)# version 3
IPv6 VRRP Commands
The following are IPv6 VRRP commands.
• clear counters vrrp ipv6
• debug vrrp ipv6
• show vrrp ipv6
• vrrp-ipv6-group
The following commands apply to IPv4 and IPv6:
• advertise-interval
• description
• disable
• hold-time
• preempt
• priority
• show config
Virtual Router Redundancy Protocol (VRRP) 1952