Users Guide

Version Description
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced support for Q-in-Q implementation over VLT on the
S-Series and Z-Series. Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.2(0.2) Introduced on the Z9000, S4810, and S4820T.
9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
9.0.2.0 Introduced on the S6000.
Example
Dell#show vlt mismatch
Domain
-------
Parameters Local Peer
---------- ----- -----
Unit-ID 1 2
Vlan-config
------------
Vlan-ID Local Mode Peer Mode
------- ---------- ---------
00 -- L3
Vlan IPV4 Multicast Status
--------------------------
Vlan-ID Local Status Peer Status
-------- ------------ -----------
4094 Active Inactive
Dell#
Example for Q-in-
Q implementation
over VLT
Dell#show vlt mismatch
Domain
------
Parameters Local Peer
---------- ----- ----
PB for stp Enabled Disabled
Vlan-type-config
----------------
Codes:: P - Primary, C - Community, I - Isolated, N - Normal
vlan, M - Vlan-stack
Vlan-ID Local Peer
------- ----- ----
100 N M
Port-type-config
----------------
Codes:: p - PVLAN Promiscuous port, h - PVLAN Host port, t -
PVLAN Trunk port,
mt - Vlan-stack trunk port, mu - Vlan-stack access port,
Virtual Link Trunking (VLT) 1908