Users Guide

Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.4(0.0) Added the support for IPV6 / IPV4.
9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
9.2(0.2) Introduced on the Z9000, S4810, and S4820T.
peer-routing-timeout
Configure the delay after which peer routing disables when the peer is unavailable. This command is
applicable for both IPv6 and IPv4.
Syntax
peer-routing-timeout value
To restore the default value, use the no peer-routing-timeout command.
Parameters
value Enter the timeout value (in seconds). The range is from 1 to
65535. The default value is infinity.
Command Modes VLT DOMAIN (conf-vlt-domain)
Default Infinity
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.7(0.0) Added support for default value on the S-Series and Z-Series.
9.5(0.1) Introduced on the Z9500.
9.4(0.0) Added the support for IPV6 / IPV4.
Virtual Link Trunking (VLT) 1900