Users Guide

maximum dynamic-routes
Specify the maximum number of dynamic (protocol) routes a VRF can have.
Syntax
maximum dynamic-routes limit {warn-threshold threshold-value |
warning-only}
To remove the limit on the maximum number of routes used, use the no maximum
dynamic-routes command.
Parameters
limit Maximum number of routes allowed in a VRF. The valid range is
from 1 to 16,000 (or maximum allowable for that platform if a
smaller value).
warning-
threshold
The warning threshold value is a percentage of the limit value.
When the number of routes reaches the specified percentage of
the limit, a warning message appears. The valid range is from 1
to 100.
After the limit is reached, additional dynamic routes are not
allowed.
warning-only When you use the warning-only option, when the maximum
number of dynamic routes reaches the limit, a warning message
appears.
After the limit is reached, additional dynamic routes are still
allowed.
Defaults No limit is set on the maximum number of dynamic routes for a VRF.
Command Modes
CONFIGURATION-VRF
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON and Z9500.
Virtual Routing and Forwarding (VRF) 1879