Users Guide

Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.3(0.0) Introduced on the S6000, S4810, S4820T, Z9000.
Usage Information
A value of 0 copies the inner packet hop limit (ipv6) or time-to-live (ipv4) in the
encapsulated packet to the tunnel header hop limit (ipv6) or time-to-live (ipv4) value.
tunnel keepalive
Configure the tunnel keepalive target, interval and attempts.
Syntax
tunnel keepalive {ip-address | ipv6-address}[interval {seconds}]
[attempts {count | unlimited}]
To disable the tunnel keepalive probes use the no tunnel keepalive command.
Parameters
ip-address ipv6
address
Enter the IPv4 or IPv6 address of the peer to which the
keepalive probes will be sent.
interval seconds
Enter the keyword interval then the interval time, in
seconds, after which the restart process to keepalive probe
packets.
The range is from 5 to 255. The default is 5.
count
(OPTIONAL) Enter the keyword count to count packets
processed by the filter.
The range is from 3 to 10. The default is 3.
Tunneling 1848