Users Guide

Version Description
9.10(0.0) Introduced on the S6000, S6000–ON, S61000–ON, Z9100–
ON.
Usage Information The xoff-state threshold polling-count command is used to set the number
of times the polling should be done. If a port/priority remains in the ‘xoff’ state for the
configured threshold number of polling-intervals, then it would be detected as PFC
storm condition. The ‘xoff’ state means no transmission of data happens out of a port/
queue even though there are packets buffered in that queue.
Example Use the storm-control pfc command in the configuration mode to enter the
‘storm-control-pfc' configuration mode. The commands provisioned in this mode are
applicable for all the interfaces that have PFC storm enabled.
Dell(conf)#storm-control pfc
Dell(conf-storm-control-pfc)#xoff-state threshold polling-count 2
Storm Control 1778