Users Guide

Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S6000, S6000–ON, S61000–ON, Z9100–
ON.
Usage Information The storm-control pfc in queue-drop-state clear command is used to clear
the queue-drop state on a particular interface where the PFC storm has been triggered.
Example
Dell(conf-if-te-0/24)# storm-control pfc in queue-drop-state clear
storm-control multicast (Configuration)
Configure the packets per second (pps) of multicast traffic allowed into the C-Series and S-Series networks
only.
Syntax
storm-control multicast packets_per_second in
To disable storm-control for multicast traffic into the network, use the no storm-
control multicast packets_per_second in command.
Parameters
packets_per_seco
nd in
Enter the packets per second of multicast traffic allowed into the
network. The range is from 0 to 33554368.
Defaults none
Command Modes CONFIGURATION (conf)
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-MUX (PMUX) mode only.
Storm Control 1773