Users Guide

storm-control pfc in queue-drop

When a PFC storm is detected on a port or priority, you can drop the traffic meant for the specified port or

priority, so that the traffic in other queues is not disturbed. You can apply storm-control pfc in queue-

drop on an interface, to enable dropping of the traffic on all the lossless queues of the port.

Syntax

storm-control pfc in queue-drop

Parameters None

Defaults None

Command Modes INTERFACE

Command History

This guide is platform-specific. For command information about other platforms, see

the relevant Dell Networking OS Command Line Reference Guide.

Version Description

9.10(0.1) Introduced on the S6010-ON and S4048T-ON.

9.10(0.0) Introduced on the S6000, S6000–ON, S61000–ON, Z9100–

ON.

Usage Information The storm-control pfc in queue-drop command is used to drop the traffic

meant for egressing through the specified port or priority where PFC storm has been

detected.

Example

Dell(conf-if-te-0/24)# storm-control pfc in queue-drop

storm-control pfc in queue-drop-state

clear

You can clear the queue-drop state on an interface where the PFC storm has been triggered.