Users Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S6010-ON

1761

Defaults 0

Command Modes CONFIGURATION (conf-storm-control-pfc)

Command History

This guide is platform-specific. For command information about other platforms, see

the relevant Dell Networking OS Command Line Reference Guide.

Version Description

9.10(0.1) Introduced on the S6010-ON and S4048T-ON.

9.10(0.0) Introduced on the S6000, S6000–ON, S61000–ON, Z9100–

ON.

Usage Information The queue-drop backoff-force polling—count command is used to remove the

queue-drop state unconditionally after the specified number of polling is done. The

queue-drop state, which has been activated due to the detection of PFC storm, is

forced to get removed. By default, the queue-drop state is not removed until it is

explicitly cleared using the storm-control pfc in queue-drop-state clear

command.

Example Use the storm-control pfc command in the configuration mode to enter the

‘storm-control-pfc' configuration mode. The commands provisioned in this mode are

applicable for all the interfaces that have PFC storm enabled.

Dell(conf)#storm-control pfc

Dell(conf-storm-control-pfc)#queue-drop backoff-force polling-

count 20

queue-drop backoff-on-norxpfc

You can remove the queue-drop state when additional PFCs are not received.

Syntax

queue-drop backoff-on-norxpfc polling-count {number of polling-

interval }

Parameters

number of

polling-interval

Enter the number of polling intervals. The range is from 0 to

1000. The default value is 10.

Defaults 10