Users Guide

polling-interval
You can set the time interval to poll the queue depth and egress counters.
Syntax
polling—interval {interval in milli-seconds}
Parameters
interval in milli-
seconds
Enter the polling interval in milliseconds. The range is 200 to
1000. The interval should be entered in multiples of 100. The
default interval value is 100 milliseconds.
Defaults 100 milli-seconds
Command Modes CONFIGURATION (conf-storm-control-pfc)
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S6000, S6000–ON, S61000–ON, Z9100–
ON.
Usage Information The polling—interval command is used to set the interval in milliseconds to poll
the queue traffic and egress counters. You can use the polling results to detect the
inconsistencies in the PAUSE frames received .
Example Use the storm-control pfc command in the configuration mode to enter the
'storm-control-pfc' configuration mode. The commands provisioned in this mode are
applicable for all the interfaces that have PFC storm enabled.
Dell(conf)#storm-control pfc
Dell(conf-storm-control-pfc)#polling-interval 200
queue-drop backoff-force
You can remove the queue-drop state after the specified number of polling is done.
Syntax
queue-drop backoff-force polling—count {number of polling—
interval }
Parameters
number of
polling-interval
Enter the number of polling intervals. The range is from 0 to
1000. The default value is 0.
Storm Control 1761