Users Guide

• show storm-control broadcast
• show storm-control multicast
• show storm-control pfc status
• show storm-control pfc statistics
• show storm-control unknown-unicast
• storm-control broadcast (Configuration)
• storm-control broadcast (Interface)
• storm-control PFC/LLFC
• storm-control pfc in queue-drop
• storm-control pfc in queue-drop-state clear
• storm-control multicast (Configuration)
• storm-control multicast (Interface)
• storm-control unknown-unicast (Configuration)
• storm-control unknown-unicast (Interface)
• xoff-state threshold polling-count
disable storm-control pfc
You can disable the PFC storm globally.
Syntax
disable
Parameters None
Defaults None
Command Modes CONFIGURATION (conf-storm-control-pfc)
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S6000, S6000–ON, S61000–ON, Z9100–
ON.
Usage Information The disable command is used to disable the PFC storm feature globally. By default,
PFC storm feature is enabled on all the interfaces on which "storm-control pfc in
queue-drop" configuration has been applied.
Example Use the storm-control pfc command in the configuration mode to enter the
'storm-control-pfc' configuration mode. The commands provisioned in this mode are
applicable for all the interfaces that have PFC storm enabled.
Dell(conf)#storm-control pfc
Dell(conf-storm-control-pfc)#disable
Storm Control 1760