Users Guide

Version Description
9.5(0.0) Introduced on the S4810, S4820T, S6000, Z9000, and MXL.
Usage Information
To display syslog messages in a RFC 3164 or RFC 5424 format, use the log version
command in configuration mode. By default, the system log version is set to 0.
The following describes the two supported log messages formats:
• 0 – Displays syslog messages format as described in RFC 3164, The BSD syslog
Protocol
• 1 – Displays SYSLOG message format as described in RFC 5424, The Syslog
Protocol
Example
Dell(conf)#logging version ?
<0-1> Select syslog version (default = 0)
Dell(conf)#logging version 1
show logging auditlog
Displays an audit log.
Syntax
show logging auditlog
Defaults None
Command Modes EXEC
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.5(0.0) Introduced on the S4810, S4820T, S6000, Z9000, and MXL.
Example
Dell(conf)# show logging auditlog
Simple Network Management Protocol (SNMP) and Syslog 1734