Users Guide

NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
hostname Enter the name of a host already configured and recognized by
the switch.
udp Enter the keyword udp to enable transmission of log message
over UDP followed by port number. The default port is 514
tcp Enter the keyword tcp to enable transmission of log message
over TCP followed by port number.
vrf vrf-name (Optional) Enter the keyword vrf and then the name of the VRF
to enable the logging process in VRF mode.
NOTE: Use this attribute to specify the VRF that is used
to contact the host. By default, the default VRF is used.
Defaults Disabled.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Added udp and tcp keywords for the Z9500.
9.5(0.0) Added udp and tcp keywords for the S4810, S4820T, S6000,
Z9000, and MXL.
9.4.(0.0) Added support for VRF.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.4.1.0 Added support for IPv6.
Simple Network Management Protocol (SNMP) and Syslog 1719