Users Guide

tacacs-server host
Specify a TACACS+ host.
Syntax
tacacs-server host {hostname | ipv4-address | ipv6-address} [port
number] [timeout seconds] [key key]
Parameters
hostname Enter the name of the TACACS+ server host.
ipv4-address |
ipv6-address
Enter the IPv4 address (A.B.C.D) or IPv6 address (X:X:X:X::X) of
the TACACS+ server host.
port number (OPTIONAL) Enter the keyword port then a number as the port
to be used by the TACACS+ server. The range is from zero (0) to
65535. The default is 49.
timeout seconds (OPTIONAL) Enter the keyword timeout then the number of
seconds the switch waits for a reply from the TACACS+ server.
The range is from 0 to 1000. The default is 10 seconds.
key key
(OPTIONAL) Enter the keyword key then a string up to 42
characters long as the authentication key. This authentication
key must match the key specified in the tacacs-server key
for the TACACS+ daemon.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.4.1.0 Added support for IPv6.
8.3.7.0 Introduced on the S4810.
Security 1602