Users Guide

ip-any Enter the keyword ip-any to support IPv4 and IPv6 traffic.
dscp-list Enter the IP DSCP values that is to be the match criteria.
Separate values by commas — no spaces ( 1,2,3 ) or indicate a
list of values separated by a hyphen (1-3). The range is from 0 to
63.
set-ip-dscp value (OPTIONAL) Enter the keywords set-ip-dscp then the IP
DSCP value. The matched traffic is marked with the DSCP value.
The range is from 0 to 63.
Defaults none
Command Modes CLASS-MAP CONFIGURATION (config-class-map)
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.0) Added the ipv6 and ip-any options on the Z9000, S6000,
S4820T, S4810, MXL.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.7.1.0 Added the keyword multicast ; added the DSCP Marking
option support on the S-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series; added support for the DSCP
Marking option.
6.2.1.1 Introduced on the E-Series.
Usage Information
To access this command, enter the class-map command. After the class map is
identified, you can configure the match criteria.
The match ip dscp and match ip precedence commands are mutually exclusive.
Quality of Service (QoS) 1432