Users Guide

Version Description
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
pre- 7.7.1.0 Introduced.
Related
Commands
• policy-map-input — creates an input policy map.
• policy-map-output — creates an output policy map.
• qos-policy-input — creates an input QoS-policy on the router.
• qos-policy-output — creates an output QoS-policy on the router.
• wred-profile — creates a WRED profile.
match ip access-group
Configure match criteria for a class map, based on the access control list (ACL).
NOTE: IPv6 class-maps and IP-any class-maps do not match. This condition is true for IPv6 and IP-any
class-maps on both ACLs as well as VLANs.
S6000–ON
Syntax
match ip access-group access-group-name [set-ip-dscp value | set-
color value]
To remove ACL match criteria from a class map, use the no match ip access-
group access-group-name [set-ip-dscp value | set-color value]
command.
Parameters
access-group-
name
Enter the ACL name whose contents are used as the match
criteria in determining if packets belong to the class the class-
map specifies.
set-ip-dscp value (OPTIONAL) Enter the keywords set-ip-dscp then the IP
DSCP value. The matched traffic is marked with the DSCP value.
The range is from 0 to 63.
set-color value (Optional) Enter the keyword set-color followed by a color
value. Traffic that fulfills the match criteria is marked with the
color value that you specify. The default value is Yellow.
Defaults none
Command Modes CLASS-MAP CONFIGURATION (config-class-map)
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Quality of Service (QoS) 1430