Users Guide

Version Description
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Added the kbps option on the C-Series, E-Series, and S-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.1 Introduced on the E-Series.
Usage Information
NOTE: Per Port rate police is supported for Layer 2 tagged and untagged
switched traffic and for Layer 3 traffic. Per VLAN rate police is supported on only
tagged ports with Layer 2 switched traffic.
S-Series
On one interface, you can configure the rate police command for a VLAN or you
can configure the rate police command for an interface. For each physical
interface, you can configure three
rate police commands specifying different
VLANS.
rate-shape
Shape the traffic output on the selected interface.
S6000–ON
Syntax
rate shape [kbps] rate [burst-KB]
Parameters
kbps Enter the keyword kbps to specify the rate limit in Kilobits per
second (Kbps). Enter the value in multiples of 64. The range is
from 0 to 40000000. The default granularity is Megabits per
second (Mbps).
rate The range is from 10 to 40000.
burst-KB (OPTIONAL) Enter the burst size in KB. The range is from 0 to
10000. The default is 50.
Defaults Granularity for rate is Mbps unless you use the kbps option.
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Quality of Service (QoS) 1421