Users Guide

Version Description
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON. Added support for VRF on S6000,
S4810, S4820T, Z9000, Z9500, and S6000–ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.1 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
7.5.1.0 Introduced on the E-Series.
Usage Information
Dell Networking OS supports standard access lists for the SSM range. You cannot use
extended ACLs for configuring the SSM range. If you configure an extended ACL and
then used in the ip pim ssm-range {access list name} configuration, an error
is reported.
However, if you configure ip pim ssm-range {access list name} first and then
you configure the ACL as an Extended ACL, an error is not reported and the ACL is not
applied to the SSM range.
Dell Networking OS-recommended best-practices are to configure the standard ACL,
and then apply the ACL to the SSM range. After the SSM range is applied, the changes
are applied internally without requiring clearing of the tree information base (TIB).
When the ACL rules change, the ACL and protocol-independent multicast (PIM)
modules apply the new rules automatically.
When you configure the SSM range, Dell Networking OS supports SSM for configured
group range as well as the default SSM range.
When you remove the SSM ACL, PIM SSM is supported for the default SSM range only.
PIM-Sparse Mode (PIM-SM) 1363