Users Guide

Usage Information The interface must be enabled (the no shutdown command) and not have the
switchport command configured. Multicast must also be enabled globally (using the
ip multicast-lag-hashing command). PIM is supported on the port-channel
interface.
ip pim sparse-mode sg-expiry-timer
Enable expiry timers globally for all sources.
Syntax
ip pim [vrf vrf-name] sparse-mode sg-expiry-timer seconds [access-
list-name]
To disable configured timers and return to default mode, use the no ip pim [vrf
vrf-name] sparse-mode sg-expiry-timer command.
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of the
VRF to enable expiry timer for all sources on that VRF.
NOTE: Applies to specific VRF if input is provided, else
applies to Default VRF.
seconds Enter the number of seconds the S, G entries are retained. The
range is from 211 to 65535.
access-list-name (OPTIONAL) Enter the name of a previously configured
Extended ACL to enable the expiry time to specified S,G entries.
Defaults Disabled. The default expiry timer (with no times configured) is 210 sec.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Added support for VRF. Removed the acl-access-list parameter.
Modified the max value of S, G entry second range from 86400
to 65535. Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
PIM-Sparse Mode (PIM-SM) 1361