Users Guide

NOTE: Applies to specific VRF if input is provided, else

applies to Default VRF.

address Enter the RP address in dotted decimal format (A.B.C.D).

group-address

mask

Enter the keywords group-address then a group-address

mask, in dotted decimal format (/xx), to assign that group

address to the RP.

override Enter the keyword override to override the BSR updates with

static RP. The override takes effect immediately during enable/

disable.

NOTE: This option is applicable to multicast group range.

Defaults Not configured.

Command Modes CONFIGURATION

Command History

This guide is platform-specific. For command information about other platforms, see

the relevant Dell Networking OS Command Line Reference Guide.

Version Description

9.10(0.1) Introduced on the S6010-ON and S4048T-ON.

9.8(1.0) Introduced on the Z9100-ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Added support for VRF. Introduced on the S6000-ON.

9.5(0.1) Introduced on the Z9500.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

8.1.1.0 Introduced on the E-Series.

7.8.1.0 Introduced on the S-Series.

pre- 6.1.1.1 Introduced on the E-Series.

Usage Information First-hop routers use this address by to send register packets on behalf of source

multicast hosts. The RP addresses are stored in the order in which they are entered. The

RP is chosen based on a longer prefix match for a group. The RP selection does not

depend on dynamic or static RP assignments.

PIM-Sparse Mode (PIM-SM) 1358