Users Guide

Command Modes
EXEC
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
9.2.(0.0) Added support for showing BFD status on the S4820T, S4810,
and Z9000.
9.1.(0.0) Added support for OSPFv3 on the S4810 and Z9000.
8.3.19.0 Introduced on the S4820T.
7.8.1.0 Added support for the C-Series.
7.4.1.0 Introduced on the E-Series.
Usage Information
If you enable BFD at the global level, show ipv6 ospf interface shows the BFD
provisioning.
If you enable BFD at the interface level, show ipv6 ospf interface shows the BFD interval
timers.
Example
Dell# show ipv6 ospf 3 interface tengigabitethernet 1/2/1
TenGigabitEthernet 1/2/1 is up, line protocol is up
Link Local Address fe80::201:e8ff:fe17:5bbd, Interface ID
67420217
Area 0, Process ID 1, Instance ID 0, Router ID 11.1.1.1
NetworkType BROADCAST, Cost: 1, Passive: No
Transmit Delay is 100 sec, State DR, Priority 1
Interface is using OSPF global mode BFD configuration.
Designated router on this network is 11.1.1.1 (local)
No backup designated router on this network
Timer intervals configured, Hello 10, Dead 40, Wait 1,
Retransmit 5
Dell#
Open Shortest Path First (OSPFv2 and OSPFv3) 1330