Users Guide

Version Description
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced to all platforms.
Usage Information
This command is either enabled or disabled. If no OSPF process is identified as the MIB
manager, the first OSPF process is used.
If an OSPF process has been selected, it must be disabled prior to assigning new
process ID the MIB responsibility.
network area
Define which interfaces run OSPF and the OSPF area for those interfaces.
S6000–ON
Syntax
network ip-address mask area area-id
To disable an OSPF area, use the no network ip-address mask area area-id
command.
Parameters
ip-address Specify a primary or secondary address in dotted decimal
format. The primary address is required before adding the
secondary address.
mask Enter a network mask in /prefix format. (/x)
area-id Enter the OSPF area ID as either a decimal value or in a valid IP
address. Decimal value range is from 0 to 65535. IP address
format is dotted decimal format A.B.C.D.
NOTE: If the area ID is smaller than 65535, it is converted
to a decimal value. For example, if you use an area ID of
0.0.0.1, it is converted to 1.
Command Modes ROUTER OSPF
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(1.0) Introduced on the Z9100-ON.
Open Shortest Path First (OSPFv2 and OSPFv3) 1240