Users Guide

Dell(conf)# no ip telnet server vrf
Dell(conf)#
ip telnet source-interface
Set an interface’s IP address as the source address in outgoing packets for Telnet sessions.
Syntax
ip telnet source-interface interface
To return to the default setting, use the no ip telnet source-interface
[interface] command.
Parameters
interface Enter the following keywords and the interface information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port/subport
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For Loopback interfaces, enter the keyword loopback
then a number from zero (0) to 16383.
• For a port channel interface, enter the keywords port-
channel
then a number.
• For VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
• For a tunnel interface, enter the keyword tunnel.
Defaults The IP address on the system that is closest to the Telnet address is used in the
outgoing packets.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
Control and Monitoring 123