Users Guide

ip telnet server vrf
Configures the TELNET server on either a specific VRF or a management VRF.
Syntax
ip telnet server vrf {vrf-name | any | management}
To undo the TELNET server configuration, use the no ip telnet server [vrf
vrf-name] command.
Parameters
vrf-name Enter the vrf-name to specify the VRF that is used by the
TELNET server.
any Enter the keyword any to enable server from any VRF.
management Enter the keyword management to specify a management VRF
that is used by the TELNET server.
Defaults Disabled
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.0) Introduced on the Z9500.
9.4.(0.0) Introduced on the S-Series and Z9000.
Usage Information You can enable the TELNET server on either a management VRF or a user-defined VRF
but not both. If you do not specify a VRF name, then the TELNET server is enabled on
the default VRF.
Example
Dell(conf)# ip telnet server vrf vrf1
Dell(conf)# no ip telnet server vrf
Dell(conf)# ip telnet server vrf management
Control and Monitoring 122