Users Guide

ipv6 nd ra-guard policy
Define the RA guard policy name and enter the RA guard policy list configuration mode.
Syntax
ipv6 nd ra-guard policy policy-name
Parameters
policy policy-
name
Enter the keyword policy then the policy-name. The policy
name allows a maximum of 140 characters.
Defaults None
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.9(0.0) Introduced on the Z9500.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S4810, S4820T, S5000, S6000, S6000–ON,
and Z9000 switches.
Related
Commands
• ipv6 nd ra-guard enable — configure the RA guard related commands.
ipv6 neighbor
Configure a static entry in the IPv6 neighbor discovery.
Syntax
ipv6 neighbor [vrf vrf-name] {ipv6-address} {interface interface}
{hardware_address}
To remove a static IPv6 entry from the IPv6 neighbor discovery, use the no ipv6
neighbor [vrf vrf-name] {ipv6-address} {interface interface}
command.
Parameters
vrf vrf-name (Optional) Enter the keyword vrf followed by the name of the
VRF to install IPv6 routes in that VRF.
Neighbor Discovery Protocol (NDP) 1161