Users Guide

Version Description
8.5.1.0 Added support for 4-port 40G line cards on E-Series.
8.3.7.0 Introduced on the S4810.
8.3.1.0 Added the vlan option on the E-Series.
7.7.1.0 Introduced on the C-Series.
7.5.1.0 Added support for the violate-action and detail options.
6.5.1.0 Added support for Port Channel.
Example
Dell# show mac learning-limit
Interface Learning Dynamic Static Unknown SA
Slot/port Limit MAC count MAC count Drops
Te 1/1/1 10 0 0 0
Te 1/2/1 5 0 0 0
Dell#show mac learning-limit interface tengigabithethernet 1/1/1
Interface Learning Dynamic Static Unknown SA
Slot/port Limit MAC count MAC count Drops
Te 1/1/1 10 0 0 0
Virtual LAN (VLAN) Commands
The following commands configure and monitor virtual LANs (VLANs). VLANs are a virtual interface and use
many of the same commands as physical interfaces.
You can configure an IP address and Layer 3 protocols on a VLAN called Inter-VLAN routing. FTP, TFTP, ACLs
and SNMP are not supported on a VLAN.
Occasionally, while sending broadcast traffic over multiple Layer 3 VLANs, the VRRP state of a VLAN interface
may continually switch between Master and Backup.
NOTE
: For more information, refer to VLAN Stacking and VLAN-related commands, such as
portmode hybrid in the Interfaces chapter.
default vlan-id
Specify a VLAN as the Default VLAN.
Syntax
default vlan-id vlan-id
To remove the default VLAN status from a VLAN and VLAN 1 does not exist, use the no
default vlan-id vlan-id syntax.
Layer 2 1051