Setup Guide

• DP values of 110 and 100, 101 map to yellow; all other values map to green.
• If you do not congure Dell EMC Networking OS to honor DSCP values on ingress (refer to Honoring DSCP Values on Ingress
Packets), all trac defaults to green drop precedence.
• Assign a WRED prole to either yellow or green trac.
QOS-POLICY-OUT mode
wred
Displaying Default and Congured WRED Proles
To display the default and congured WRED proles, use the following command.
• Display default and congured WRED proles and their threshold values.
EXEC mode
show qos wred-profile
Displaying WRED Drop Statistics
To display WRED drop statistics, use the following command.
• Display the number of packets Dell EMC Networking OS the WRED prole drops.
EXEC Privilege mode
show qos statistics wred-profile
Example of the show qos statistics wred-profile Command
Displaying egress–queue Statistics
To display the number of transmitted and dropped packets and their rate on the egress queues of an interface, use the following command:
• Display the number of packets and number of bytes on the egress-queue prole.
EXEC Privilege mode
show qos statistics egress-queue
Example of show qos statistics egress-queue Command
Pre-Calculating Available QoS CAM Space
Before Dell EMC Networking OS version 7.3.1, there was no way to measure the number of CAM entries a policy-map would consume (the
number of CAM entries that a rule uses is not predictable; from 1 to 16 entries might be used per rule depending upon its complexity).
Therefore, it was possible to apply to an interface a policy-map that requires more entries than are available. In this case, the system writes
as many entries as possible, and then generates an CAM-full error message (shown in the following example). The partial policy-map
conguration might cause unintentional system behavior.
%EX2YD:12 %DIFFSERV-2-DSA_QOS_CAM_INSTALL_FAILED: Not enough space in L3
Cam(PolicyQos) for class 2 (TeGi 12/20) entries on portpipe 1
The test cam-usage command allows you to verify that there are enough available CAM entries before applying a policy-map to an
interface so that you avoid exceeding the QoS CAM space and partial congurations. This command measures the size of the specied
policy-map and compares it to the available CAM space in a partition for a specied port-pipe.
686
Quality of Service (QoS)