Setup Guide
• removes the resequence command from EXEC mode by requiring a minimum of privilege level 4
• moves the capture bgp-pdu max-buffer-size command from EXEC Privilege to EXEC mode by requiring a minimum privilege
level 3, which is the congured level for VTY 0
• allows access to CONFIGURATION mode with the banner command
• allows access to INTERFACE tengigabitethernet and LINE modes are allowed with no commands
• Remove a command from the list of available commands in EXEC mode.
CONFIGURATION mode
privilege exec level level {command ||...|| command}
• Move a command from EXEC Privilege to EXEC mode.
CONFIGURATION mode
privilege exec level level {command ||...|| command}
• Allow access to CONFIGURATION mode.
CONFIGURATION mode
privilege exec level level configure
• Allow access to INTERFACE, LINE, ROUTE-MAP, and/or ROUTER mode. Specify all the keywords in the command.
CONFIGURATION mode
privilege configure level level {interface | line | route-map | router} {command-keyword
||...|| command-keyword}
• Allow access to a CONFIGURATION, INTERFACE, LINE, ROUTE-MAP, and/or ROUTER mode command.
CONFIGURATION mode
privilege {configure |interface | line | route-map | router} level level {command ||...||
command}
Example of EXEC Privilege Commands
Applying a Privilege Level to a Username
To set the user privilege level, use the following command.
• Congure a privilege level for a user.
CONFIGURATION mode
username username privilege level
Applying a Privilege Level to a Terminal Line
To set a privilege level for a terminal line, use the following command.
• Congure a privilege level for a user.
CONFIGURATION mode
username username privilege level
NOTE
: When you assign a privilege level between 2 and 15, access to the system begins at EXEC mode, but the prompt is
hostname#, rather than hostname>.
60 Management