Setup Guide

! Version 9.4(0.0)
! Last configuration change at Tue Mar 11 21:33:56 2014 by admin
! Startup-config last updated at Tue Mar 11 12:11:00 2014 by default
!
<output truncated for brevity>
Managing the File System
The Dell EMC Networking system can use the internal Flash, external Flash, or remote devices to store les.
The system stores les on the internal Flash by default but can be congured to store les elsewhere.
To view le system information, use the following command.
• View information about each le system.
EXEC Privilege mode
show file-systems
The output of the show file-systems command in the following example shows the total capacity, amount of free memory, le
structure, media type, read/write privileges for each storage device in use.
DellEMC#show file-systems
Size(b) Free(b) Feature Type Flags Prefixes
520962048 213778432 dosFs2.0 USERFLASH rw flash:
127772672 21936128 dosFs2.0 USERFLASH rw slot0:
- - - network rw ftp:
- - - network rw tftp:
- - - network rw scp:
You can change the default le system so that le management commands apply to a particular device or memory.
To change the default directory, use the following command.
• Change the default directory.
EXEC Privilege mode
cd directory
View Command History
The command-history trace feature captures all commands entered by all users of the system with a time stamp and writes these
messages to a dedicated trace log buer.
The system generates a trace message for each executed command. No password information is saved to the le.
NOTE
:
The timestamps display format of the show command history output changes based on the service timestamps log
datetime conguration. The time format can be in uptime, local time zone time or UTC time.
If timestamp is disabled (no service timestamps log) then command history time format is shown with timestamp defaults
(service timestamps log datetime localtime).
To view the command-history trace, use the show command-history command.
Example of the show command-history Command
Example 1: Default conguration service timestamps log datetime or service timestamps log datetime
localtime
DellEMC(conf)#service timestamps log datetime
54
Getting Started