Setup Guide
EXEC Privilege mode
show vlan
Conguring VLAN Tags for Member Interfaces
To congure and verify VLAN tags for individual members of a port channel, perform the following:
1 Congure VLAN membership on individual ports
INTERFACE mode
DellEMC(conf-if)#vlan tagged 2,3-4
2 Use the switchport command in INTERFACE mode to enable Layer 2 data transmissions through an individual interface
INTERFACE mode
DellEMC(conf-if)#switchport
3 Verify the manually congured VLAN membership (show interfaces switchport interface command).
EXEC mode
Assigning an IP Address to a Port Channel
You can assign an IP address to a port channel and use port channels in Layer 3 routing protocols.
To assign an IP address, use the following command.
• Congure an IP address and mask on the interface.
INTERFACE mode
ip address ip-address mask [secondary]
– ip-address mask: enter an address in dotted-decimal format (A.B.C.D). The mask must be in slash format (/24).
– secondary: the IP address is the interface’s backup IP address. You can congure up to eight secondary IP addresses.
Deleting or Disabling a Port Channel
To delete or disable a port channel, use the following commands.
• Delete a port channel.
CONFIGURATION mode
no interface portchannel channel-number
• Disable a port channel.
shutdown
When you disable a port channel, all interfaces within the port channel are operationally down also.
Interfaces
373