Setup Guide

Example of the ip ecmp-group maximum-paths Command
DellEMC(conf)#ip ecmp-group maximum-paths 3
User configuration has been changed. Save the configuration and reload to take effect
DellEMC(conf)#
Creating an ECMP Group Bundle
Within each ECMP group, you can specify an interface.
If you enable monitoring for the ECMP group, the utilization calculation is performed when the average utilization of the link-bundle (as
opposed to a single link within the bundle) exceeds 60%.
1 Create a user-dened ECMP group bundle.
CONFIGURATION mode
ecmp-group ecmp-group-id
The range is from 1 to 64.
2 Add interfaces to the ECMP group bundle.
CONFIGURATION ECMP-GROUP mode
interface interface
3 Enable monitoring for the bundle.
CONFIGURATION ECMP-GROUP mode
link-bundle-monitor enable
Modifying the ECMP Group Threshold
You can customize the threshold percentage for monitoring ECMP group bundles.
To customize the ECMP group bundle threshold and to view the changes, use the following commands.
• Modify the threshold for monitoring ECMP group bundles.
CONFIGURATION mode
link-bundle-distribution trigger-threshold {percent}
The range is from 1 to 90%.
The default is 60%.
• Display details for an ECMP group bundle.
EXEC mode
show link-bundle-distribution ecmp-group ecmp-group-id
The range is from 1 to 64.
300
Equal Cost Multi-Path (ECMP)