Setup Guide

Fields Description
• Feature: for legacy DCBx versions
• Symmetric: for an IEEE version
TLV Tx Status Status of PFC TLV advertisements: enabled or disabled.
PFC Link Delay Link delay (in quanta) used to pause specied priority trac.
Application Priority TLV: FCOE TLV Tx Status Status of FCoE advertisements in application priority TLVs from
local DCBx port: enabled or disabled.
Application Priority TLV: ISCSI TLV Tx Status Status of ISCSI advertisements in application priority TLVs from
local DCBx port: enabled or disabled.
Application Priority TLV: Local FCOE Priority Map Priority bitmap used by local DCBx port in FCoE advertisements in
application priority TLVs.
Application Priority TLV: Local ISCSI Priority Map Priority bitmap used by local DCBx port in ISCSI advertisements in
application priority TLVs.
Application Priority TLV: Remote FCOE Priority Map Status of FCoE advertisements in application priority TLVs from
remote peer port: enabled or disabled.
Application Priority TLV: Remote ISCSI Priority Map Status of iSCSI advertisements in application priority TLVs from
remote peer port: enabled or disabled.
PFC TLV Statistics: Input TLV pkts Number of PFC TLVs received.
PFC TLV Statistics: Output TLV pkts Number of PFC TLVs transmitted.
PFC TLV Statistics: Error pkts Number of PFC error packets received.
PFC TLV Statistics: Pause Tx pkts Number of PFC pause frames transmitted.
PFC TLV Statistics: Pause Rx pkts Number of PFC pause frames received
The following example shows the show interface pfc statistics command.
The following example shows the show interface ets summary command.
The following example shows the show interface ets detail command.
The following table describes the show interface ets detail command elds.
Table 24.
show interface ets detail Command Description
Field Description
Interface Interface type with and port number.
Maximum Supported Maximum number of priority groups supported.
Number of Trac Classes Number of 802.1p priorities currently congured.
Admin mode ETS mode: on or o.
Admin Parameters ETS conguration on local port, including priority groups, assigned
dot1p priorities, and bandwidth allocation.
Remote Parameters ETS conguration on remote peer port, including Admin mode
(enabled if a valid TLV was received or disabled), priority groups,
assigned dot1p priorities, and bandwidth allocation. If the ETS
Data Center Bridging (DCB) 267