Setup Guide

• (Optional) Display the conguration of tracked objects in VRRP groups on a specied interface.
EXEC mode or EXEC Privilege mode
show running-config interface interface
Examples of Conguring and Viewing the track Command
The following example shows how to congure tracking using the track command.
The following example shows how to verify tracking using the show conf command.
The following example shows verifying the tracking status.
The following example shows verifying the VRRP status.
The following example shows verifying the VRRP conguration on an interface.
Setting VRRP Initialization Delay
When congured, VRRP is enabled immediately upon system reload or boot. You can delay VRRP initialization to allow the IGP and EGP
protocols to be enabled prior to selecting the VRRP Master. This delay ensures that VRRP initializes with no errors or conicts. You can
congure the delay for up to 15 minutes, after which VRRP enables normally.
Set the delay timer on individual interfaces. The delay timer is supported on all physical interfaces, VLANs, and LAGs.
When you congure both CLIs, the later timer rules VRRP enabling. For example, if you set vrrp delay reload 600 and vrrp
delay minimum 300, the following behavior occurs:
• When the system reloads, VRRP waits 600 seconds (10 minutes) to bring up VRRP on all interfaces that are up and congured for
VRRP.
• When an interface comes up and becomes operational, the system waits 300 seconds (5 minutes) to bring up VRRP on that interface.
To set the delay time for VRRP initialization, use the following commands.
• Set the delay time for VRRP initialization on an individual interface.
INTERFACE mode
vrrp delay minimum seconds
This time is the gap between an interface coming up and being operational, and VRRP enabling.
The seconds range is from 0 to 900.
The default is 0.
• Set the delay time for VRRP initialization on all the interfaces in the system congured for VRRP.
INTERFACE mode
vrrp delay reload seconds
This time is the gap between system boot up completion and VRRP enabling.
The seconds range is from 0 to 900.
The default is 0.
Virtual Router Redundancy Protocol (VRRP)
1043