White Papers

Stack MAC : 90:b1:1c:f4:a7:c7
Reload-Type : normal-reload [Next boot : normal-reload]
-- Stack Info --
Unit UnitType Status ReqTyp CurTyp Version Ports
------------------------------------------------------------------------------------
0 Member not present S6000
1 Member not present
2 Standby online S6000 S6000 1-0(0-3387) 128
3 Member not present S6000
4 Member not present
5 Management online S6000 S6000 1-0(0-3387) 128
-- Power Supplies --
Unit Bay Status Type FanStatus FanSpeed(rpm)
---------------------------------------------------------------------------
2 0 up AC up 6720
2 1 up AC up 6688
5 0 up AC up 6688
5 1 down UNKNOWN down 0
-- Fan Status --
Unit Bay TrayStatus Fan0 Speed Fan1 Speed
------------------------------------------------------------------------------------
2 0 up up 7072 up 6971
2 1 up up 7021 up 7021
2 2 up up 7021 up 6971
5 0 up up 7021 up 7123
5 1 up up 6971 up 7021
5 2 up up 7021 up 6971
Speed in RPM
Add Units to an Existing Stack
You can add units to an existing stack in one of three ways.
• By manually assigning a new uncongured unit a position in an existing stack.
• By adding a congured unit to an existing stack.
• By merging two stacks.
If you are adding units to an existing stack, you can either:
• allow Dell EMC Networking OS to automatically assign the new unit a position in the stack, or
• manually determine each units position in the stack by conguring each unit to correspond with the stack before connecting it.
• If you add a unit that has a stack number that conicts with the stack, the stack assigns the rst available stack number.
• If the stack has a provision for the stack-number that will be assigned to the new unit, the provision must match the unit type, or Dell
EMC Networking OS generates a type mismatch error.
After the new unit loads, it synchronizes its running and startup congurations with the stack.
Manually Assigning a New Unit to an Existing Stack
To manually assign a new unit a position in an existing stack, use the following steps.
1 On the stack, determine the next available stack-unit number, and the management priority of the management unit.
EXEC Privilege mode
show system brief or show system stack-unit
2 On the new unit, number it the next available stack-unit number.
906
Stacking