White Papers

CLI Command Mode Prompt Access Command
UPLINK STATE GROUP
DellEMC(conf-uplink-state-
group-groupID)#
uplink-state-group
The following example shows how to change the command mode from CONFIGURATION mode to PROTOCOL SPANNING TREE.
Example of Changing Command Modes
DellEMC(conf)#protocol spanning-tree 0
DellEMC(config-span)#
The do Command
You can enter an EXEC mode command from any CONFIGURATION mode (CONFIGURATION, INTERFACE, SPANNING TREE, and so
on.) without having to return to EXEC mode by preceding the EXEC mode command with the do command.
The following example shows the output of the do command.
DellEMC(conf)#do show system brief
Stack MAC : 00:01:e8:00:66:64
Reload-Type : normal-reload [Next boot : normal-reload]
-- Stack Info --
Unit UnitType Status ReqTyp CurTyp Version Ports
------------------------------------------------------------------------
0 Management online S4810 S4810 9.4(0.0) 64
1 Member not present
2 Member not present
3 Member not present
4 Member not present
5 Member not present
6 Member not present
7 Member not present
8 Member not present
9 Member not present
10 Member not present
11 Member not present
-- Power Supplies --
Unit Bay Status Type FanStatus
---------------------------------------------------------------
0 0 absent absent
0 1 up UNKNOWN up
-- Fan Status --
Unit Bay TrayStatus Fan0 Speed Fan1 Speed
------------------------------------------------------------------
0 0 up up 9120 up 9120
0 1 up up 9120 up 9120
Speed in RPM
DellEMC(conf)#
Undoing Commands
When you enter a command, the command line is added to the running conguration le (running-cong).
To disable a command and remove it from the running-cong, enter the no command, then the original command. For example, to delete
an IP address congured on an interface, use the no ip address ip-address command.
NOTE
: Use the help or ? command as described in Obtaining Help.
42 Conguration Fundamentals