Users Guide

interface TenGigabitEthernet 1/2
no ip address
switchport
no shutdown
Dell(conf-if-range-gi-1/1-2)#
show interfaces
Display information on a specific physical interface or virtual interface.
Syntax
show interfaces interface-type[—range]
Parameters
interface Enter one of the following keywords and the interface information:
● For a Loopback interface, enter the keyword loopback then a number from 0
to 16383.
● For stack-units, enter the keywords stack-unit then the slot/port
information.
● For a Null interface, enter the keyword null then the Null interface number.
● For a port channel interface, enter the keywords port-channel then a
number.
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
●
For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
● For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
● For a tunnel interface, enter the keyword tunnel then the tunnel ID. The
range is from 1 to 16383.
NOTE: This command also enables you to view information corresponding to a
range of ports. However, for Open Networking (ON) platforms the notation for
specifying port range in the command is different from how you specify in non-
ON platforms.
-range (Optional) Enter the range of interfaces for which you want to view the
information. The format is interface-type slot/port-port-slot/port
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.9(0.0) Added support to display the interface configurations corresponding to a range of
ports.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.2(0.2) Added support for the tunnel interface type.
Interfaces 591