Setup Guide

DellEMC(conf)#no service timestamps log
DellEMC#show clock
15:55:12.246 IST Fri May 17 2019
DellEMC# show command-history
[May 17 15:53:10]: CMD-(CLI):[no service timestamps log]by default from console
[May 17 15:53:16]: CMD-(CLI):[write memory]by default from console
- Repeated 3 times.
[May 17 15:53:22]: CMD-(CLI):[show logging]by default from console
- Repeated 1 time.
[May 17 15:53:36]: CMD-(CLI):[write memory]by default from console
- Repeated 5 times.
[May 17 15:53:44]: CMD-(CLI):[show logging]by default from console
[May 17 15:53:53]: CMD-(CLI):[show command-history]by default from console
[May 17 15:54:54]: CMD-(CLI):[end]by default from console
[May 17 15:55:00]: CMD-(CLI):[show logging]by default from console
[May 17 15:55:12]: CMD-(CLI):[show clock]by default from console
[May 17 15:55:22]: CMD-(CLI):[show running-config]by default from console
[May 17 15:55:27]: CMD-(CLI):[show command-history]by default from console
DellEMC# show logging
Syslog logging: enabled
Console logging: disabled
Monitor logging: level debugging
Buffer logging: level debugging, 3 Messages Logged, Size (40960 bytes)
Trap logging: level informational
Last logging buffer cleared: May 17 15:52:54
%STKUNIT1-M:CP %SYS-5-CONFIG_I: Configured from console
%STKUNIT1-M:CP %FILEMGR-5-FILESAVED: Copied running-config to startup-config in flash by
default - repeated 3 times
%STKUNIT1-M:CP %FILEMGR-5-FILESAVED: Copied running-config to startup-config in flash by default
File Transfer Services
With Dell EMC Networking OS, you can congure the system to transfer les over the network using the le transfer protocol (FTP).
One FTP application is copying the system image les over an interface on to the system; however, FTP is not supported on virtual local
area network (VLAN) interfaces.
The FTP and TFTP services are enhanced to support the VRF-aware functionality. If you want the FTP or TFTP server to use a VRF table
that is attached to an interface, you must congure the FTP or TFTP server to use a specic routing table. You can use the ip ftp vrf
vrf-name or ip tftp vrf vrf-name command to inform the FTP or TFTP server to use a specic routing table. After you congure
this setting, the VRF table is used to look up the destination address. However, these changes are backward-compatible and do not aect
existing behavior; meaning, you can still use the
source-interface command to communicate with a particular interface even if no
VRF is congured on that interface.
For more information about FTP, refer to RFC 959, File Transfer Protocol.
NOTE
: To transmit large les, Dell EMC Networking recommends conguring the switch as an FTP server.
Conguration Task List for File Transfer Services
The conguration tasks for le transfer services are:
• Enable FTP Server (mandatory)
• Congure FTP Server Parameters (optional)
• Congure FTP Client Parameters (optional)
Management
81