Reference Guide

950 | Virtual Router Redundancy Protocol (VRRP)
www.dell.com | support.dell.com
description
z
Configure a short text string describing the VRRP group.
Syntax
description text
To delete a VRRP group description, enter no description.
Parameters
Defaults
Not enabled.
Command Modes
VRRP
Command
History
disable
z
Disable a VRRP group.
Syntax
disable
To re-enable a disabled VRRP group, enter no disable.
Defaults
S-Series default: VRRP is enabled.
Command Modes
VRRP
Command
History
Usage
Information
To enable VRRP traffic, assign an IP address to the VRRP group using the virtual-address command
and enter no disable.
Related
Commands
hold-time
z
Specify a delay (in seconds) before a switch becomes the MASTER virtual router. By delaying the
initialization of the VRRP MASTER, the new switch can stabilize its routing tables.
Syntax
hold-time seconds
To return to the default value, enter no hold-time.
S6000
text
Enter a text string up to 80 characters long.
Version 9.0.2.0 Introduced on S6000.
Version 8.3.11.1 Introduced on Z9000.
S6000
Version 9.0.2.0 Introduced on S6000.
Version 8.3.11.1 Introduced on Z9000.
virtual-address Specify the IP address of the Virtual Router.
S6000