Reference Guide

Virtual Router Redundancy Protocol (VRRP) | 949
Parameters
Command Modes
EXEC Privilege
Command
History
debug vrrp
z
Allows you to enable debugging of VRRP.
Syntax
debug vrrp interface [vrrp-id] {all | bfd | packets | state | timer}
To disable debugging, use the no debug vrrp interface [vrrp-id] {all | database | interface |
packets | state | timer} command.
Parameters
Command Modes
EXEC Privilege
Command
History
Usage
Information
If no options are specified, debug is active on all interfaces and all VRRP groups.
vrrp-id
(OPTIONAL) Enter the number of the VRRP group ID.
Range: 1 to 255
Version 9.0.2.0 Introduced on S6000.
Version 8.3.11.1 Introduced on Z9000.
S6000
interface
Enter the following keywords and slot/port or number information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by
the slot/port information.
• For Port Channel interface types, enter the keyword
port-channel followed by the
number:
S-Series Range: 1-128
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
FortyGigabitEthernet
followed by the slot/port information.
• For a VLAN interface, enter the keyword
vlan followed by the VLAN ID. The VLAN
ID range is from 1 to 4094.
vrrp-id
(OPTIONAL) Enter a number from 1 to 255 as the VRRP group ID.
all Enter the keyword all to enable debugging of all VRRP groups.
database Enter the keyword database to enable configuration to change information.
interface Enter the keyword interface to enable state to change information.
packets Enter the keyword packets to enable debugging of VRRP control packets.
state Enter the keyword state to enable debugging of VRRP state changes.
timer Enter the keyword timer to enable debugging of the VRRP timer.
Version 9.0.2.0 Introduced on S6000.
Version 8.3.11.1 Introduced on Z9000.