Reference Guide

942 | VLAN Stacking
www.dell.com | support.dell.com
Usage
Information
vlan-stack access
z
Specify a Layer 2 port or port channel as an access port to the Stackable VLAN network.
Syntax
vlan-stack access
To remove access port designation, enter no vlan-stack access.
Defaults
Not configured.
Command Modes
INTERFACE
Command
History
Usage
Information
Prior to enabling this command, you must enter the switch port command to place the interface in
Layer 2 mode.
To remove the access port designation, the port must be removed (using the no member interface
command) from all Stackable VLAN enabled VLANs.
vlan-stack compatible
z
Enable the Stackable VLAN feature on a VLAN.
Syntax
vlan-stack compatible
To disable the Stackable VLAN feature on a VLAN, enter no vlan-stack compatible.
Defaults
Not configured.
Command Modes
CONF-IF-VLAN
Command
History
Warning: The following message is displayed to confirm the command:
All non-default configurations on the related member ports
ports (<ports listed here>) will be removed. Do you want to
continue (y/n)?
If “y” is entered, all non-default configurations on any member ports of the current stack group
will be removed when the unit is rebooted.
S6000
Version 9.0.2.0 Introduced on S6000.
Version 8.3.11.1 Introduced on Z9000
S6000
Version 9.0.2.0 Introduced on S6000.
Version 8.3.11.1 Introduced on Z9000.
Version 8.3.7.0 Introduced on S4810.