Reference Guide

Spanning Tree Protocol (STP) | 913
Command Modes
EXEC Privilege
Command
History
Usage
Information
When you enable debug spanning-tree bpdu for multiple interfaces, the software only sends
information on BPDUs for the last interface specified.
Related
Commands
description
z
Enter a description of the Spanning Tree
Syntax
description {description}
To remove the description from the Spanning Tree, use the no description {description} command.
Parameters
Defaults
No default behavior or values
Command Modes
SPANNING TREE (The prompt is “config-stp”.)
Command
History
Related
Commands
disable
z
Disable Spanning Tree Protocol globally on the switch.
Syntax
disable
To enable Spanning Tree Protocol, enter no disable.
Defaults
Enabled (that is, Spanning Tree Protocol is disabled.)
Command Modes
SPANNING TREE
general (OPTIONAL) Enter the keyword general to debug general STP operations.
root (OPTIONAL) Enter the keyword root to debug STP root transactions.
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on Z9000
protocol spanning-tree Enter SPANNING TREE mode on the switch.
S6000
description
Enter a description to identify the Spanning Tree (80 characters maximum).
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on Z9000
protocol spanning-tree Enter SPANNING TREE mode on the switch.
S6000