Reference Guide

Storm Control | 909
Command
History
Usage
Information
Unknown Unicast Storm-Control is valid for Layer 2 and Layer 2/Layer 3 interfaces.
storm-control unknown-unicast (Interface)
z
Configure percentage of unknown-unicast traffic allowed on an interface (ingress only).
Syntax
storm-control unknown-unicast [percentage decimal_value in] | [wred-profile name]]
[packets_per_second in]
To disable unknown-unicast storm control on the interface, use the no storm-control
unknown-unicast [percentage decimal_value in] | [wred-profile name]] [packets_per_second
in] command.
Parameters
Defaults
No default behavior or values
Command Modes
INTERFACE (conf-if-interface-slot/port)
Command
History
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on Z9000
S6000
percentage
decimal_value in
Enter the percentage of broadcast traffic allowed in to the network. Optionally,
you can designate a decimal value percentage, for example, 55.5%.
Percentage: 0 to 100
0% blocks all related traffic
100% allows all traffic into the interface
Decimal Range: .1 to .9
wred-profile name (Optionally) Enter the keyword wred-profile followed by the profile name to
designate a wred-profile.
packets_per_second in
S-Series Only: Enter the packets per second of broadcast traffic allowed into the
network.
S-Series Range: 0 to 33554431
S4810 Range: 0 to 33554368
The minimum number of PPS limited on the S4810 is 2
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on Z9000