Reference Guide

908 | Storm Control
www.dell.com | support.dell.com
storm-control multicast (Interface)
z
Configure the percentage of multicast traffic allowed on an S-Series interface (ingress only) network
only.
Syntax
storm-control multicast packets_per_second in
To disable multicast storm control on the interface, use the no storm-control multicast
packets_per_second in command.
Parameters
Defaults
No default behavior or values
Command Modes
INTERFACE (conf-if-interface-slot/port)
Command
History
storm-control unknown-unicast (Configuration)
z
Configure the percentage of unknown-unicast traffic allowed in or out of the network.
Syntax
storm-control unknown-unicast [percentage decimal_value [in | out]] | [wred-profile
name]] [packets_per_second in]
To disable storm control for unknown-unicast traffic, use the no storm-control unknown-unicast
[percentage decimal_value [in | out] | [wred-profile name]] [packets_per_second in] command.
Parameters
Defaults
No default behavior or values
Command Modes
CONFIGURATION
S6000
packets_per_second in
S-Series Only: Enter the packets per second of broadcast traffic allowed into the
network.
S-Series Range: 0 to 33554431
S4810 Range: 0 to 33554368
The minimum number of PPS limited on the S4810 is 2
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on Z9000
S6000
percentage
decimal_value [in |
out]
Enter the percentage of broadcast traffic allowed in or out of the network.
Optionally, you can designate a decimal value percentage, for example, 55.5%.
Percentage: 0 to 100
0% blocks all related traffic
100% allows all traffic into the interface
Decimal Range: .1 to .9
wred-profile name (Optionally) Enter the keyword wred-profile followed by the profile name
to designate a wred-profile.
packets_per_second in
S-Series Only: Enter the packets per second of broadcast traffic allowed into
the network.
Range: 0 to 33554431
The minimum number of PPS limited on the S4810 is 2