Reference Guide

Storm Control | 907
Parameters
Defaults
No default behavior or values
Command Modes
INTERFACE (conf-if-interface-slot/port)
Command
History
storm-control multicast (Configuration)
z
Configure the packets per second (pps) of multicast traffic allowed in to the S-Series networks only.
Syntax
storm-control multicast packets_per_second in
To disable storm-control for multicast traffic into the network, use the no storm-control multicast
packets_per_second in command.
Parameters
Defaults
No default behavior or values
Command Modes
CONFIGURATION (conf)
Command
History
Usage
Information
Broadcast traffic (all 0xFs) should be counted against broadcast storm control meter, not against the
multicast storm control meter. It is possible, however, that some multicast control traffic may get
dropped when storm control thresholds are exceeded.
percentage
decimal_value in
Enter the percentage of broadcast traffic allowed in to the network. Optionally,
you can designate a decimal value percentage, for example, 55.5%.
Percentage: 0 to 100
0% blocks all related traffic
100% allows all traffic into the interface
Decimal Range: .1 to .9
wred-profile name (Optionally) Enter the keyword wred-profile followed by the profile name to
designate a wred-profile.
packets_per_second in
S-Series Only: Enter the packets per second of broadcast traffic allowed into the
network.
S-Series Range: 0 to 33554431
S4810 Range: 0 to 33554368
The minimum number of PPS limited on the S4810 is 2.
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on Z9000
S6000
packets_per_second in
S-Series Only: Enter the packets per second of multicast traffic allowed into the
network followed by the keyword
in.
S-Series Range: 0 to 33554431
S4810 Range: 0 to 33554368
The minimum number of PPS limited on the S4810 is 2
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on Z9000