Reference Guide

904 | Storm Control
www.dell.com | support.dell.com
• When broadcast storm control is enabled on an interface or globally on ingress, and DSCP
marking for a DSCP value 1 is configured for the data traffic, the traffic will go to queue 1 instead
of queue 0.
• Similarly, if unicast storm control is enabled on an interface or globally on ingress, and DSCP
marking for a DSCP value 2 is configured for the data traffic, the traffic will go to queue 2 instead
of queue 0.
show storm-control broadcast
z
Display the storm control broadcast configuration.
Syntax
show storm-control broadcast [interface]
Parameters
Defaults
No default behavior or values
Command Modes
EXEC
EXEC Privilege
Command
History
show storm-control multicast
z
Display the storm control multicast configuration.
Syntax
show storm-control multicast [interface]
Note: Bi-directional traffic (unknown unicast and broadcast), along with egress storm
control, causes the configured traffic rates to be split between the involved ports. The
percentage of traffic that each port receives after the split is not predictable. These ports can
be in the same/different port pipes, or the same/different stack-units.
S6000
interface
(OPTIONAL) Enter one of the following interfaces to display the interface specific storm
control configuration.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by
the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed
by the slot/port information.
• Fast Ethernet is not supported.
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on Z9000
S6000